Varahi MHI

Inspect any machine by asking it.

Varahi MHI puts a 3D model of your machine and an AI assistant in one workspace. Ask in chat or by voice, and the model opens the part, the panel or the exploded view you asked for.

Watch the workspace demo See agent mode

Shown on an EV, a sedan CAD model, a twin-engine jet and a screw vacuum pump.

Highlighted
50%
Illustration of the exploded-view control, not a product screenshot.
The machines

One interface for many machines

MHI shows real-time analysis of a machine next to a workspace where you can ask the AI about it. The same interface has been shown on four different machines.

  • EV

    A sample model with a dummy interface. It is the vehicle used in the agent demo.

  • Sedan

    Built from an actual CAD model, so you can go into the complete detail of the model.

  • Twin-engine jet

    Wings, flight controls and individual components open from chat or voice.

  • Screw vacuum pump

    An OEM component, opened in the same workspace as the vehicles.

The workspace

Open a machine, then ask about it

Open any machine and the workspace loads with the details for that model. Chat, the 3D view and the side panel stay together, so you never leave the machine to ask a question.

Workspace demo. Open on Loom if the video does not load.

Chat that stays on the part

Open a section and the chat covers only that part. The complete assembly stays on screen beside it.

Ask for a view and get a panel

Ask the AI to open the flight controls on the jet. They open with their details in the right-hand panel. Drafting for an individual component opens the same way.

Voice mode

Speak the request. The assistant answers and moves the model.

YouHighlight wings on Jet, please, and explode to fifty percent. AssistantOkay, I’m adjusting the wings to 50% for diagnostics.
Agent mode

Start a case, then approve the result

Pick a vehicle and start a case. In the demo, a line replay starts and an agent inspects the EV on its own, step by step, while you watch it work in 3D.

Agent mode demo. Open on Loom if the video does not load.

  1. Reads the overnight alarms
  2. Analyses cell spread
  3. Inspects the vehicle step by step
  4. Builds the warranty evidence pack
  5. You approve or reject the claim

A terminal and an outputs panel sit beside the case. They hold the diagrams and technical detail the agent produced, and the claim it made. The agent submits nothing until you approve it.

Scope

From the EV demo to your machine

The EV in the agent demo is a dummy interface. The same approach is being applied to actual CAD models and to machines such as the jet and the screw vacuum pump, with the aim of fitting any OEM machine. The recordings are demos on sample models, not customer results.